Cisco 6160 Manual de procedimientos de instalación - Página 19
Navegue en línea o descargue pdf Manual de procedimientos de instalación para Hardware de red Cisco 6160. Cisco 6160 32 páginas. Without a pots splitter configuration
También para Cisco 6160: Manual de consulta rápida (38 páginas), Manual de instalación del hardware (21 páginas), Notas de instalación y sustitución (18 páginas)
Imprimir página
Chapter 4
Installing a Cisco 6160 Without a POTS Splitter Configuration
On the first subtended node chassis backplane, attach the end of the coaxial cable used in
Step 9
TX BNC connector for DS3 Port 1 on the I/O card.
Repeat
Step 10
4.2.10.2 OC-3c Subtending Connections
Complete the following steps to connect the OC-3c subtending connections:
Do not stare into the beam or view it directly with optical instruments.
Warning
For more information about OC-3c subtending connections, see the
Note
with OC-3c/OC-3c NI-2 Cards" section on page
Verify that the OC-3c/OC-3c NI-2 card is installed in slot 10 (or slot 11, if a secondary NI-2 card is
Step 1
installed for redundancy) of the Cisco 6160 chassis to ensure that the OC-3c NI-2 card connections are
active.
Note
Attach a cable to the SBTD 2 RX optical interface connector on the subtending host chassis
Step 2
OC-3c/OC-3c NI-2 card to the TRNK 1 TX optical interface connector on the subtended node chassis
OC-3c/OC-3c NI-2 card.
Figure 4-11
Note
Figure 4-11 Cabling for OC-3c Subtended Network Configuration
Network
trunk
Attach a cable to the SBTD 2 TX optical interface connector on the subtending host chassis
Step 3
OC-3c/OC-3c NI-2 card to the TRNK 1 RX optical interface connector on the subtended node chassis
OC-3c/OC-3c NI-2 card. (See
OL-2190-02 B0
Step 2
through
Step 9
for each subtending host chassis.
See the
"Redundancy in Subtended Configurations" section on page 1-42
about redundant configurations.
shows the cabling for an OC-3c subtended network configuration.
See
Table 2-4
for cable specifications. See
Top
chassis
Cisco 6160
Cisco 6160
Figure
1-10.
Figure 1-17
1st subtended
2nd subtended
chassis
Cisco 6160
Cisco 6160
4-11.)
Cisco 6160 Hardware Installation Guide
Installation Procedures
"Subtended Network Configuration
for more information
for OC-3c connector locations.
chassis
Cisco 6160
Up to 10 more
subtended
chassis
Cisco 6160
Step 8
to the
4-19