Cisco 7507 Manual de inicio rápido - Página 32
Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Cisco 7507. Cisco 7507 44 páginas. Air filter and chassis blower replacement
También para Cisco 7507: Manual de instrucciones de instalación (39 páginas), Ficha de datos (11 páginas), Manual de instrucciones de sustitución (21 páginas)
Imprimir página
Install Field Replaceable Units (FRUs)
Step 8
If you have a VIP4 and are using HSA
with an RSP2 as the slave processor, wait
20-30 seconds, then reinsert the RSP2.
Step 9
Repeat Step 2 through Step 8 to remove
any additional interface processors, fillers,
VIPs, or RSPs.
Step 10
Perform the steps in the "Install Interface
Processors, Fillers, VIPs, or RSPs" section
on page 10 to install an interface
processor, filler, VIP, or RSP.
Check the RSP Installation
Step 1
Check the RSP connections to make sure
they are secure:
•
The RSP is inserted all the way into its slot, and
30
both the captive installation screws are
tightened.
•
The console terminal is turned on and is
connected to the console port.
Step 2
Observe the RSP LEDs. While the system
initializes, the CPU halt LED on the RSP
stays on. It goes off when the boot process
is complete. As the RSP initializes each
interface processor, the status LEDs on
each interface processor go on and off in
irregular sequence.
Step 3
Verify that the console terminal displays
the system banner and startup screen as
the system restarts.
Note
Boot time is approximately 1 minute for
systems with one RSP and approximately 1.5
minutes for systems with two RSPs.
Step 4
Verify that all the enabled LEDs (on the
interface processors) are on.
Step 5
In systems with a second RSP installed
(and HSA or HA configured), use the
show version command to verify that the
slave (or standby) RSP is recognized by
the system.
Step 6
When you have verified all the conditions
in Step 1 through Step 4 (or Step 5 if you
have a second RSP installed and want to
use the HSA or HA features), the
installation is complete.
If you replaced the RSP and saved your configuration
file to a remote server before doing so, proceed to the
"Retrieve the Configuration File for RSPs" section
on page 35.
An error condition exists if no LEDs go on at power
up or after initialization, or if the boot error or CPU
halt LEDs go on and remain on. If this happens, see
Appendix A in the Cisco 7500 Series Installation and
Configuration Guide.