Cisco 7513 Series Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Cisco 7513 Series. Cisco 7513 Series 44 páginas. Chassis replacement
También para Cisco 7513 Series: Manual de instrucciones de sustitución (26 páginas), Ficha de datos (11 páginas), Manual (30 páginas), Mantener (20 páginas), Manual de instrucciones de sustitución (19 páginas), Manual de instrucciones de sustitución (22 páginas)

Cisco 7513 Series Manual de inicio rápido
Install the Hardware
Install the Router on a Bench or Tabletop
Note
To rack-mount the router, refer to the
"Rack-Mount the Router (Recommended)" section
on page 4.
Caution
Two people are required to
perform this step. Avoid sudden twists or
moves to prevent injury.
Step 1
With a person positioned at either side of
the chassis, grasp the bottom edge of the
chassis with one hand near the front and
the other near the back. Slowly lift the
chassis in unison. Place the chassis on a
bench or tabletop where the air intake
vent on the front of the chassis is not
drawing in exhaust air from other
equipment.
POWER
A
POWER
B
Warning
lift by grasping the handle of the blower
module, nor should you grasp the air intake
grill.
Step 2
Ensure that you have at least 2 or 3 feet
(0.6 to .09 m) of clearance around the rear
of the chassis to install power supplies and
perform maintenance on the chassis.
Step 3
Proceed to the "Install Interface
Processors, Fillers, VIPs, or RSPs" section
on page 9.
When lifting the router, do not
3