Cisco ACIP-SM= Manual de instalación y configuración - Página 28
Navegue en línea o descargue pdf Manual de instalación y configuración para Hardware de red Cisco ACIP-SM=. Cisco ACIP-SM= 33 páginas. Atm cable interface processor (acip)
Imprimir página
Examples of ATM Error Messages
•
After you use a debug command, turn off debugging with the no debug command.
Following are additional debug commands specifically related to the ACIP:
•
•
•
Examples of ATM Error Messages
Following is a list of possible error messages displayed when you enter the debug atm event
command:
Error Message
RESET(ATM2/0): PLIM type is 0, Rate is 0Mbps
Explanation
rate.
Error Message
AIP_disable(ATM2/0): state=1
Explanation
Error Message
config(ATM2/0)
Explanation
exception queue length, raw queue length, and rate queue information.
Error Message
AIP_enable(ATM2/0)
Explanation
28 ATM Cable Interface Processor (ACIP) Installation and Configuration
To display ATM events, use the debug atm events command:
This command displays event changes to the ACIP. Reset, VC configurations, ACIP
configurations, and PLIM failures are displayed.
To display changes in connectivity to the TeraLink system, use the debug cable channel
command.
To display changes in subscriber modem status, use the debug cable modem command.
To display error messages that are caused by unexpected system behavior or problems
connecting to the Teralink system, use the debug cable error command.
Displays the PLIM TYPE value returned from the ACIP and the expected associated
The DISABLE code to shut the ACIP down has been entered.
The current configuration to the ACIP was sent including TXBUFF, RXBUFF,
The ACIP is taken out of shutdown.