Cisco Aironet 340 Series Manual de inicio rápido - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Cisco Aironet 340 Series. Cisco Aironet 340 Series 16 páginas. Usb client adapter
También para Cisco Aironet 340 Series: Manual de inicio rápido (12 páginas), Manual de inicio rápido (13 páginas), Notas de publicación (14 páginas), Manual de inicio rápido (12 páginas), Manual de inicio rápido (12 páginas)

Determine Conﬁguration Method (continued)

Remote Conﬁguration through an Access Point

Note

The workgroup bridge communicates only with Cisco Aironet Access Points.

Adjust the following settings on the access point to allow it to communicate with the

bridge:

— On the access point's Express

Setup management page, set

the access point's SSID to

tsunami, which matches the

bridge's default SSID.

— On the access point's AP

Radio Data Encryption

management page, set the

encryption mode to off.

To conﬁgure the bridge using a computer connected to your network with an access point

and DHCP server, continue with Steps 2 through 4.

If you do not have a DHCP server, set your PC to an address of 192.168.200.5. Then open

the browser or Telnet to 192.168.200.1. Skip to the "Conﬁgure the Bridge" section.

Place the bridge in the vicinity of an access point and plug in the power adapter.

The bridge communicates with the access point when you apply power to the bridge. If

your network uses a DHCP server, and if the bridge's Ethernet port is connected to a device,

the bridge receives an IP address on your network. When the bridge's IP address is changed

from the default setting, it can no longer be set using the IPSU.

When the status LED on the bridge is green (to show association of the bridge to the access

point), go to the association table. Find the entry WGB3XX_xxxxxx (xxxxxx is the last

six digits of the access point's MAC address).

Record the IP address of that entry. Browse to the bridge's management home page and

complete the conﬁguration by following the steps in the "Conﬁgure the Bridge" section.

Access point

Workgroup

bridge

Workstation

on the wireless LAN

File server

Wired LAN

Workstation

on the wired LAN