Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr Manual de servicio - Página 12

Navegue en línea o descargue pdf Manual de servicio para Cámara digital Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr. Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr 30 páginas. Interchangeable lens digital camera/zoom lens kit
También para Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr: Manual de funciones (7 páginas), Especificaciones (2 páginas)

Imprimir página
Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr Manual de servicio

NOTE FOR REPAIR

• Make sure that the flat cable and flexible board are not cracked or
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, do not pull at wire of connector. It is
possible that a wire is snapped.
• When installing a connector, do not press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
DISCHARGING OF THE CHARGING CAPACITOR
The charging capacitor is charged up to the maximum 330 V
potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the unit is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of
a resistor of 1 kΩ /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.
Wrap insulating tape.

SUBSIDIARY MATERIALS

G: Grease
G-15 (J-6082-619-A)
G-85 (J-6082-626-A)
G-116 (J-6082-628-A)
SLT-A33/A33L/A33Y/A55/A55V/A55L/A55VL/A55VY_L2
– ENGLISH –
Cut and remove the part of gilt
which comes off at the point.
(Be careful that some
pieces of gilt may be left inside)
Note:
Note:
High-voltage cautions
High-voltage cautions
Discharging the Capacitor
Short-circuit between the two points with the
Short-circuit between the two points with the
short jig about 10 seconds.
short jig about 10 seconds.
To avoid the spark with the metal plate,
To avoid the spark with the metal plate,
wrap the short jig with the insulation tape.
wrap the short jig with the insulation tape.
ST-233 Complete Board
R:1 kΩ/1 W
(Part code: 1-215-869-11)
2-2
G
– JAPANESE –
Note:
ST-233
R:1 kΩ/1 W
(
: 1-215-869-11)