Sony XCD-V60 Manual técnico - Página 7

Navegue en línea o descargue pdf Manual técnico para Cámara digital Sony XCD-V60. Sony XCD-V60 39 páginas. Digital camera module
También para Sony XCD-V60: Manual (4 páginas), Manual técnico (38 páginas), Manual de servicio (30 páginas), Instrucciones de uso (2 páginas)

Imprimir página

Installation

Fitting the lens

Remove the lens mount cap.

Screw in the lens (not supplied), and turn it until it

is secured.

Note

Clean the optical filter with a commercially available

blower brush to remove dust.

Using a tripod

To use the tripod, install the VCT-ST70I tripod adaptor

(not supplied) on the camera module.

Use a tripod screw with a protrusion (

from the installation surface, as follows, and tighten the

screw using a hand screwdriver.

: 4.5 to 5.5 mm (0.18 to 0.22 inches)

Note

When you install the tripod adaptor, use the screws

supplied with the tripod adaptor.

Connecting the camera cable

Connect a commercially available IEEE1394b camera

cable to the IEEE1394b connector and the 1394b

interface connector of your PC. When you connect the

cable, insert the cable connector into the IEEE1394b

connector until it snaps into place, holding it. Then,

tighten the fixing screws placed on both sides of the

cable connector.

1 IEEE1394b connector

2 Fixing screws

3 IEEE1394b camera cable (not supplied)

4 IEEE1394b connector cap

The IEEE1394b connector on the right has a cover cap

exclusively for this camera. If you use this connector,

remove the cap. The unused connector shall be covered

with the cap.

Note

Loose fixing screws may cause a poor connection or

damage to the camera or cable. Be sure to tighten the

fixing screws.

When power supply from the

IEEE1394b connector is

insufficient

Power can be supplied to the camera module via the DC-

700/700CE camera adaptor (optional) and a camera

cable such as CCXC-12P05N (optional) if power supply

) extending

from the IEEE1394b connector is insufficient.

1 12-pin I/O connector

2 Camera cable (e.g. CCXC-12P05N)

3 to AC power source

4 CAMERA connector

5 AC IN connector

6 Trigger generator