Cisco APP-LSS Instalación y actualización - Página 10

Navegue en línea o descargue pdf Instalación y actualización para Hardware de red Cisco APP-LSS. Cisco APP-LSS 32 páginas. Fddi card and appliques

Installation Prerequisites

Slot priorities are set to accommodate the amount of trafﬁc generated by each interface card and the

amount of card buffering required. Each ciscoBus interface card is placed in a speciﬁc slot with

regard to other ciscoBus interface cards, if any. The order of priority is the same for both ﬁrst- and

second-generation ciscoBus cards, except that the cards with the designation C2 can only be used

with the CSC-CCTL2.

Following is a list of ciscoBus interface cards in order of priority, from highest to lowest:

Install CSC-MEC or C2MEC cards in the lowest-numbered slots, beginning with slot 0 (which has

the highest priority), followed by CSC-C2CTR cards. After all CSC-MEC and CSC-C2CTR cards

are installed, install CSC-HSCI and C2HSCI cards with the APP-LHS applique in the

lowest-numbered slots available. Follow with the CSC-FCI and C2FCI cards. Next, install

CSC-C2FCIT cards. Last, install the CSC-HSCI and C2HSCI cards with the APP-ULA (UltraNet)

applique. Always install cards in the lowest-numbered available slot. For example, if you are using

only CSC-C2HSCI cards (with APP-ULA), place the ﬁrst in slot 0, the second in slot 1, and so forth.

Table 2 lists the maximum port and card conﬁgurations for all of the ciscoBus cards currently

available. Use this table as a guide when installing new ciscoBus cards and reconﬁguring your

AGS+.

10 Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

CSC-MEC and C2MEC (10 megabits per second [Mbps])

CSC-C2CTR (16 Mbps)

CSC-HSCI and C2HSCI with an APP-LHS applique (High-Speed Serial Interface) (45 through

52 Mbps)

CSC-FCI and C2FCI (100 Mbps)

CSC-C2FCIT (100 Mbps)

CSC-HSCI and C2HSCI with an APP-ULA applique (UltraNet interface) (125 Mbps)