Cisco ASA 5506-X Montar y conectar

Navegue en línea o descargue pdf Montar y conectar para Hardware de red Cisco ASA 5506-X. Cisco ASA 5506-X 12 páginas. Threat defense reimage guide
También para Cisco ASA 5506-X: Manual de inicio rápido (10 páginas), Manual de inicio rápido (14 páginas), Manual de instalación sencilla (11 páginas), Manual de software (37 páginas), Manual de instalación (46 páginas), Montar el chasis (10 páginas), Manual de instalación del hardware (26 páginas)

Mount and Connect

Note

Do not remove the rubber feet included with the ASA because they are needed for proper cooling for all

mounting orientations.

This chapter describes how to rack-mount the ASA, and how to connect the cords and cables. It contains the

following sections:

•

Desktop Mount the ASA

You can mount the ASA on a desktop by placing it on a desk in a horizontal position. Make sure there are no

blockages or obstructions within one inch of the top of the ASA or within .5 inch of the sides and back, so

that nothing interferes with cooling. Do not remove the rubber feet included with the ASA. They are also

needed for proper cooling.

Caution

Do not stack the ASA chassis on top of another ASA chassis. If you stack the units, they will overheat, which

causes the units to power cycle.

Desktop Mount the ASA, on page 1

Wall Mount the ASA, on page 2

Rack Mount the ASA, on page 3

Install the ASA 5506H-X in a DIN Rail, on page 4

Connect Cables, Turn on Power, and Verify Connectivity, on page 6

Connect to a Console Terminal or PC, on page 8

Mount and Connect