Sony MEX-BT3700U Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Sistema estéreo Sony MEX-BT3700U. Sony MEX-BT3700U 45 páginas. Bluetooth audio system
También para Sony MEX-BT3700U: Instalación/Conexiones (2 páginas), Especificaciones (2 páginas), Manual rápido (2 páginas), Instalación/Conexiones (2 páginas), Manual rápido (2 páginas)
Imprimir página
Canceling the DEMO mode
You can cancel the demonstration display which
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "DEMO" appears.
3
Rotate the control dial to select
"DEMO-OFF."
4
Press and hold the select button.
The setup is complete and the display returns
to normal play/reception mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 25.
Setting the clock
The clock uses a l2-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press
(SEEK)
+.
The hour indication flashes.
4
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
(SEEK)
+/-.
5
After setting the minute, press the
select button.
The setup is complete and the clock starts.
To display the clock, press
(DSPL).
Press
( DSPL)
again to return to the previous display.
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you tum the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press
(OFF).
The unit is turned off.
2
Press
~,
then pUll it off towards you.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heatlhigh
temperature or moisture. Avoid leaving it in
a
parked
_
car or on
a
dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.
Attaching the front panel
Engage part @ of the front panel with part
®
of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
7