Cisco ASA 5506W-X Manual de software - Página 9

Navegue en línea o descargue pdf Manual de software para Hardware de red Cisco ASA 5506W-X. Cisco ASA 5506W-X 37 páginas. Threat defense reimage guide
También para Cisco ASA 5506W-X: Manual de inicio rápido (10 páginas), Manual de configuración (13 páginas), Manual de inicio rápido (14 páginas), Manual de instalación sencilla (11 páginas), Montar y conectar (12 páginas), Manual de instalación (46 páginas), Montar el chasis (10 páginas)

Imprimir página

Cisco ASA and Firepower Threat Defense Reimage Guide

ADDRESS=10.86.118.3

NETMASK=255.255.255.0

SERVER=10.86.118.21

GATEWAY=10.86.118.21

VLAN=untagged

IMAGE=ftd-boot-latest.lfbff

CONFIG=

LINKTIMEOUT=20

PKTTIMEOUT=4

RETRY=20

rommon 6 > sync

Updating NVRAM Parameters...

rommon 7 > tftpdnld

Ping to troubleshoot connectivity to the server:

rommon 1 > ping 10.123.123.2

Sending 10, 32-byte ICMP Echoes to 10.123.123.2 timeout is 4 seconds

!!!!!!!!!!

Success rate is 100 percent (10/10)

rommon 2 >

Step 6

Enter setup, and configure network settings for the Management interface to establish temporary connectivity

to the HTTP or FTP server so that you can download and install the system software package.

Note

Example:

firepower-boot>

firepower-boot>setup

Welcome to Cisco FTD Setup

[hit Ctrl-C to abort]

Default values are inside []

Enter a hostname [firepower]: example.cisco.com

Do you want to configure IPv4 address on management interface?(y/n) [Y]: y

Do you want to enable DHCP for IPv4 address assignment on management interface?(y/n) [Y]:

Enter an IPv4 address: 10.123.123.123

If you have a DHCP server, the FTD automatically sets the network configuration. See the following

sample startup messages when using DHCP:

Configuring network interface using DHCP

Bringing up network interface.

Depending on your network, this might take a couple of minutes when using DHCP...

ifup: interface lo already configured

Using IPv4 address: 10.123.123.123

Using IPv6 address: fe80::2a0:c9ff:fe00:0

Using DNS server: 64.102.6.247

Using DNS server: 173.36.131.10

Using default gateway: 10.123.123.1

Cisco FTD Boot 6.3.0

Type ? for list of commands

Reimage from ASA to Firepower Threat Defense

Cisco ASA and Firepower Threat Defense Reimage Guide