Sony MHC-MG510AV Manual de instrucciones - Página 34

Navegue en línea o descargue pdf Manual de instrucciones para Sistema estéreo Sony MHC-MG510AV. Sony MHC-MG510AV 41 páginas. Sony operating instructions mini hi-fi component system mhc-mg510av,mhc-mg310av,mhc-mg110
También para Sony MHC-MG510AV: Manual de instrucciones (40 páginas)

Imprimir página
Troubleshooting
(continued)
Tuner
Tape
Deck
The tape does not record.
l
No tape m the cassette holder.
l
The tab has been removed from the cassette. (see
"To save a tape permanently"
on page 3 1).
l
The tape has reeled to the end.
The tape does not record
nor play or there IS a
decrease
m sound
level.
l
The heads are dirty (see "Cleamng
the tape
heads" on page 32).
l
The record/playback
heads are magnetized
(see
"Demagnetlzmg
the tape heads" on page 32).
The tape does not erase completely.
l
The record/playback
heads are magnetized
(see
"Demagnetlzmg
the tape heads" on page 32).
There
IS excesswe
wow or flutter,
or the sound
drops
out.
l
The capstans or pmch rollers are dirty (see
"Cleamng
the tape heads" on page 32).
Noise increases
or the high frequencies
are
erased.
l
The record/playback
heads are magnetized
(see
"Demagnetlzmg
the tape heads" on page 32).
After pressing
+
W (or k
on the remote)
or
=, there IS a mecharucal
noise,
"EJECT"
appears,
and the system
enters
standby
mode
automatically.
l
The tape was not loaded correctly.
There
IS
severe
hum or noise ("TUNED"
01
"STEREO"
flashes
m the display).
l
Adjust the antenna.
l
The ugnal strength IS too weak. Connect the
external antenna.
l
The supplied FM antenna recewes signals along
Its entue length, so make sure you extend It fully.
l
Locate the antennas as far away from the speaker
cords as possible.
l
Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
l
Try turmng off surrounding
electrical
equpments.
A stereo
FM program
cannot
be received
In
stereo.
l
Press STEREO/MONO
so that "STEREO"
appears.
If other
troubles
not described
above
occur,
reset the system
as follows:
1
Unplug
the power
cord.
2 Plug the power
cord
back
In.
3 Press
I/b
to turn on the system.
4 Press
W, CLEAR,
and DISPLAY
at the
same
time.
The system IS reset to the factory settings. All
the settings you made are cleared. Be sure to
restore all necessary settings.
One of the following messages may appear or
flash m the display durmg operation.
NO DISC
l
There IS no CD m the disc slot.
OVER
* You have reached the end of the CD.
34