Sony PFV-SP3300 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Sistema estéreo Sony PFV-SP3300. Sony PFV-SP3300 18 páginas. Signal processing unit, backup power supply unit
También para Sony PFV-SP3300: Manual de instalación (16 páginas), Manual de instrucciones (18 páginas), Manual de mantenimiento (40 páginas)

Imprimir página

4 Cover plates

Remove the corresponding plates to install the optional

boards.

5 REF IN (reference input) connectors (BNC type)

The connectors accept two (A and B) analog reference

video signals (black burst signals or tri-level sync

signals for HDTV).

Two connectors of each pair have internal loop-

through connections. If loop-through output signals

are not used, put a 75-ohm terminator on any

connector that is not used.

6 ~AC IN A connector

To supply power to power unit A, connect to an AC

power supply using one of the following power cords:

Model available in North America:

Part No. 1-557-377-11

Model available in the United Kingdom:

Part No. 1-782-929-11

7 ~AC IN B connector

To supply power to power unit B, connect to an AC

power supply using one of the following power cords:

Model available in North America:

Part No. 1-557-377-11

Model available in the United Kingdom:

Part No. 1-782-929-11

8 U (signal ground) terminal

For signal ground. Connect to a ground wire as

required.

9 STATUS OUT connector (Mini D-sub 15-pin)

Outputs the statuses of the unit in the same manner as

the front-panel indicators.

For details, refer to the installation manual.

0 REMOTE connector (BNC type)

The connector is an S-BUS connector to be used for

routing switcher control. When a board installed in

this unit requires S-BUS communication with the

PFV-SP3300 main frame, connect an S-BUS control

line to this connector.

5 (E)