Sony RCD-W222ES - Cd/cdr Recorder Manual de instrucciones - Página 20
Navegue en línea o descargue pdf Manual de instrucciones para Sistema estéreo Sony RCD-W222ES - Cd/cdr Recorder. Sony RCD-W222ES - Cd/cdr Recorder 34 páginas. Limited warranty (es products)
También para Sony RCD-W222ES - Cd/cdr Recorder: Manual de instrucciones (32 páginas), Especificaciones (2 páginas), Garantía limitada (1 páginas)
You can start recording from the end of the
existing material. Before recording, see "Notes
on Recording" on page 16.
When using the remote, set SELECT to CDR.
l
After recording, you must finalize the disc.
Until the disc is properly finalized, it cannot
be played on any other machine. See
"Finalizing a CD-R or CD-RW" on page 24.
OPEN/CLOSE
INPUT
II
REC.
SELECl
INPUT
D
II
REC 0
w
1
Turn on the amplifier
and the sound
source, and then select the sound
source on the amplifier.
2 Press OPEN/CLOSE of DECK B and
place a recordable
CD-R or CD-RW on
DECK B.
Press OPEN/CLOSE
again to close the
disc tray.
With the label side up
3 Press INPUT repeatedly
to select the
input connector.
To record through
Turn on the indicator
DIGITAL OPTICAL IN OPTICAL
DIGITAL COAXIAL IN COAXIAL
ANALOG IN
ANALOG
To record the disc in DECK A, turn off
"OPTICAL," "COAXIAL,"or "ANALOG."
4
Press REC 0.
DECK B stands by for recording
5 Adjust the recording
level, if necessary.
For details, see "Adjusting the Recording
Level" on page 2 1.
6
Press )
(or
D
on the remote).
7 Start playing the sound source you
want to record.
To pause
recording
Press II. To resume recording, press the button
again or press )
(or
D
on the remote).
Note
Whenever you pause recording, a new track number
is added. For example, if you paused recording
while
recording on track 4, the track number increases by
one and
recording continues on the new track when
recording is resumed.
To stop
recording
Press H.
"PMA Writing" appears while updating the
information of the disc before stopping the
recording.
Notes
l
If you press RBC 0 during recording, you can add
a track (page 22). The track must be longer than 4
seconds.
* When recording from more than one disc manually,
the silence between tracks may become longer. To
prevent this, use Synchro-Recording.
l
This unit uses the Serial Copy Management System,
which allows only first-generation digital copies to
be made of premastered software via the unit's
digital input. Therefore you may not be able to
record a CD-R or CD-RW digitally through the
DIGITAL OPTICAL IN or DIGITAL COAXIAL
IN jack depending on the content being recorded.
l
Because of the restriction of the Serial Copy
Management System (SCMS), you may not be able
to make digital recordings. In this case, use analog
recording through the ANALOG IN jack when you
record from other units. Or use Synchro-Recording
when you record from DECK A. (The recording
mode is automatically changed to analog recording.)