Sony SS-CN345 Manual de servicio - Página 2
Navegue en línea o descargue pdf Manual de servicio para Sistema estéreo Sony SS-CN345. Sony SS-CN345 16 páginas. Micro satellite system
También para Sony SS-CN345: Manual de servicio (16 páginas)
Imprimir página
SA-VE345/WMS345/SS-CN345/V345
Ver 1.1
Supplied accessories
Foot pads (20)
Audio connecting cord (1)
Speaker connecting cords, 10 m (32.8 ft) (2)
Speaker connecting cords, 3.5 m (11.5 ft) (3)
Design and specifications are subject to change without
notice.
• Abbreviation
CND : Canadian model
AUS : Australian model
SP
: Singapore model
MY
: Malaysia model
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, "metallized" knobs, screws,
and all other exposed metal parts for AC leakage. Check leakage as
described below.
LEAKAGE TEST
The AC leakage from any exposed metal part to earth ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microamperes).
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
WT-540A. Follow the manufacturers' instructions to use these
instruments.
2. A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a VOM
or battery-operated AC voltmeter. The "limit" indication is 0.75
V, so analog meters must have an accurate low-voltage scale. The
Simpson 250 and Sanwa SH-63Trd are examples of a passive
VOM that is suitable. Nearly all battery operated digital
multimeters that have a 2V AC range are suitable. (See Fig. A)
To Exposed Metal
Parts on Set
0.15µF
1.5k Ω
Earth Ground
Fig. A. Using an AC voltmeter to check AC leakage.
2
1-1. Circuit Boards Location (SA-WMS345) ............................ 3
1-2. Printed Wiring Boards (SA-WMS345) ............................... 5
1-3. Schematic Diagram (SA-WMS345) ................................... 6
2-1. Front Panel Section (SA-WMS345) .................................... 7
2-2. Rear Panel Section (SA-WMS345) ..................................... 8
2-3. Center Speaker Section (SS-CN345) .................................. 9
2-4. Front and Surround Speakers Section (SS-V345) ............. 10
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
AC
voltmeter
(0.75V)
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES
SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT.
NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES
SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL
OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
TABLE OF CONTENTS
......................................... 11
SAFETY-RELATED COMPONENT WARNING!!
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!