Cisco ATM Cable Interface Processor ACIP-SM(=) Manual de instalación y configuración - Página 16
Navegue en línea o descargue pdf Manual de instalación y configuración para Hardware de red Cisco ATM Cable Interface Processor ACIP-SM(=). Cisco ATM Cable Interface Processor ACIP-SM(=) 33 páginas. Atm cable interface processor (acip)
Imprimir página
Installing and Removing an ACIP
Installing and Removing an ACIP
An ACIP slides into slots in the rear of a Cisco 7500 series chassis and connects directly to the
backplane. The backplane slots are keyed so that the ACIP can be installed only in the slots
designated for it. (For interface processor slot locations, refer to section "Hardware and Host Router
Prerequisites" on page 9.) Figure 9 shows the procedures for removing and installing an ACIP.
When tightened, the captive installation screws on the ends of the ACIP faceplate help ensure proper
seating in the backplane. After using the ejector levers to install an ACIP, immediately tighten the
captive installation screws to prevent an ACIP from becoming partially dislodged from the
backplane, and before installing additional processors; this will help reduce the effects of EMI.
Caution
hang the system.
Figure 9
A
B
C
16 ATM Cable Interface Processor (ACIP) Installation and Configuration
Failure to use ejector levers could result in a partial backplane connection, which can
Installing and Removing an ACIP
Card carrier guide (black)
Captive
installation
screw
Remove a module as follows:
1. Use a screwdriver to loosen the captive installation
screws (shown in A).
2. Simultaneously pull the ejector levers out to release
the module from the backplane connector (shown in B).
The levers should snap into their spring retainers.
3. Grasp the module handle with one hand and place your
other hand under the carrier to support and guide the
module as you pull it out of the slot. Avoid touching the card.
4. Place the removed module on an antistatic mat or antistatic
foam, or immediately install it in another slot.
5. Install a new module or a filler (MAS7K-BLANK) to keep
dust out of the chassis and to maintain proper airflow
through the chassis.
Install a module as follows:
1. Choose a slot for the new module and ensure that there is
enough clearance to accommodate any interface equipment
that you will connect directly to its ports.
2. Use a screwdriver to loosen the captive installation screws
(shown in A) and remove the filler (or the existing module)
from the slot to be filled.
3. Hold the module handle with one hand, and place your
other hand under the carrier to support the module and guide
it into the slot. Avoid touching the card.
4. Place the back of the module in the slot and align the guide
on the carrier with the groove in the slot (shown in A).
5. Carefully slide the module into the slot until the faceplate
makes contact with the ejector levers (shown in C).
6. Use the thumb and forefinger of each hand to push the
ejector lever flat against the module (shown in B).
7. Use a screwdriver to tighten the captive installation screws.