Cisco CAB-SM-LCSC-1M Notas de instalación - Página 16
Navegue en línea o descargue pdf Notas de instalación para Hardware de red Cisco CAB-SM-LCSC-1M. Cisco CAB-SM-LCSC-1M 36 páginas. Passive optical system
También para Cisco CAB-SM-LCSC-1M: Notas de instalación (42 páginas)
Imprimir página
Installing the CWDM Passive Optical System
Secure the 2-slot chassis using four (two per side) 12-24 x 3/4-inch screws or four 10-32 x 3/4-inch
Step 3
screws. Thread the screws through the elongated holes in the L bracket and into the threaded holes in the
mounting post. (See
Figure 15
Installing the CWDM OADM Modules
Caution
When performing the following procedures, wear a grounding strap to avoid ESD damage to the OADM
module. Make sure the other end of the ground strap is securely attached to a grounded point.
To install the CWDM OADM modules, follow these steps:
Align the CWDM OADM module with the slot on the 2-slot chassis. (See
Step 1
Figure 16
CWDM-
OADM4-1
Cisco CWDM Passive Optical System Installation Note
16
Figure
15.)
Mounting the 2-Slot Chassis in the Rack
Installing a CWDM OADM Module
TX
NETWORK
RX
TX
PASS
RX
TX
1470
RX
TX
1510
RX
MONITOR
TX
RX
MONITOR
TX
RX
1490
TX
RX
TX
1530
RX
TX
NETWORK
RX
TX
PASS
RX
TX
1550
RX
TX
1590
RX
CWDM-
OADM4-2
MONITOR
TX
MONITOR
RX
TX
RX
1570
TX
RX
TX
1610
RX
Figure
16.)
78-16565-02