Cisco Catalyst 3560-E Series Manual de introducción - Página 17

Navegue en línea o descargue pdf Manual de introducción para Hardware de red Cisco Catalyst 3560-E Series. Cisco Catalyst 3560-E Series 25 páginas. Switches and power supply modules
También para Cisco Catalyst 3560-E Series: Boletín de productos (5 páginas), Preguntas y respuestas (3 páginas), Boletín de asistencia sobre productos (2 páginas), Boletín de asistencia sobre productos (5 páginas), Notas de instalación (20 páginas)

Connecting to the Switch Ports

This section describes how to connect to the fixed switch ports, to the 10-Gigabit Ethernet module

slots, and to the SFP module slots. Some switch models might not include 10/100/1000 Ethernet ports,

10/100/1000 PoE ports, or SFP slots.

Connect to 10/100/1000 Ports

The 10/100/1000 Ethernet ports use standard RJ-45 connectors with Ethernet pinouts. The maximum

cable length is 328 feet (100 meters). The 100BASE-TX and 1000BASE-T traffic requires Category 5,

Category 5e, or Category 6 UTP cable. The 10BASE-T traffic can use Category 3 or Category 4 cable.

The autonegotiation feature is enabled by default on the switch. At this setting, the switch ports

configure themselves to operate at the speed of attached devices. If the attached device does not

support autonegotiation, you can explicitly set the switch port speed and the duplex parameters. To

maximize performance, either let the ports autonegotiate both speed and duplex, or set the port speed

and duplex parameters on both ends of the connection.

For simplified cabling, the automatic medium-dependent interface crossover (auto-MDIX) feature is

enabled by default on the switch. With auto-MDIX enabled, the switch detects the required cable type

for copper Ethernet connections and configures the interface accordingly. Therefore, you can use either

a crossover or a straight-through cable for connections to a switch 10/100/1000 Ethernet port,

regardless of the type of device on the other end of the connection.

See the switch software configuration guide or the switch command reference on Cisco.com for more

information about enabling or disabling autonegotiation and auto-MDIX.

Connect to 10/100/1000 PoE Ports

The 10/100/1000 PoE ports have the same default settings and cabling requirements that are described

in the previous section.

The PoE ports provide PoE support for devices compliant with IEEE 802.3af and also provide Cisco

pre-standard PoE support for Cisco IP Phones and Cisco Aironet Access Points.

Each port can deliver up to 15.4 W of PoE. With the 1150-W power supply module, the

Catalyst 3560E-48PS switch can deliver 15.4 W on all 48 ports. With the 750-W power supply

module, the switches can deliver 15.4 W of PoE on any 24 of the 48 ports, or any combination of the

ports can deliver an average of 7.7 W of PoE at the same time, up to a maximum switch power output

of 370 W. On a per-port basis, you can control whether or not a PoE port automatically provides

power when an IP phone or an access point is connected.

See the hardware installation guide on Cisco.com for more information about the switch power supply

options.