(Optional) You can select the Advanced Settings tab on the Express Setup window and enter
Step 15
the advanced settings now or enter them later by using the device manager interface.
(Optional) Enter this information in the Advanced Setting fields:
Step 16
• In the Telnet Access field, click Enable if you are going to use Telnet to manage the
switch by using the command-line interface (CLI). If you enable Telnet access, you must
enter a Telnet password.
• In the Telnet Password field, enter a password. The Telnet password can be from 1 to
25 alphanumeric characters, is case sensitive, allows embedded spaces, but does not
allow spaces at the beginning or end. In the Confirm Telnet Password field, re-enter the
Telnet password.
• In the SNMP field, click Enable to enable Simple Network Management Protocol
(SNMP). Enable SNMP only if you plan to manage switches by using CiscoWorks 2000
or another SNMP-based network-management system.
• If you enable SNMP, you must enter a community string in the SNMP Read Community
field, the SNMP Write Community field, or both. SNMP community strings
authenticate access to MIB objects. Embedded spaces are not allowed in SNMP
community strings. When you set the SNMP read community, you can access SNMP
information, but you cannot change it. When you set the SNMP write community, you
can both access and change SNMP information.
• In the System Contact and System Location fields, enter a contact name and the wiring
closet, floor, or building where the switch is located.
(Optional) You can enable IPv6 on the switch in the Advanced Settings screen. In the Enable
Step 17
IPv6 field, click Enable to enable IPv6 on the switch. Note: Enabling IPv6 restarts the switch
when you complete Express Setup.
7
Imprimir página