Argo-Hytos 376402 Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Unidad de control Argo-Hytos 376402. Argo-Hytos 376402 4 páginas. Digital control electronics unit

Imprimir página
Block Diagram
IN
3
2
GND
1
+VDC
1
9÷36 V DC
2
0 V
3
0÷10 V
4÷20 V
0÷5 V
GND
0 V signal
3
1
2
IN
+VDC
GND
REF
Wiring Diagram
1) EXTERNAL INPUT SIGNAL CONNECTION
("in" set to "10")
2) POTENTIOMETER CONNECTION
("in" set to "5")
3) RAMP UP & DOWN ONLY OPERATION
("in" set to "5")
4) EXTERNAL INPUT SIGNAL CONNECTION 4-20 mA
("in" set to "420")
5) TWO WIRE TRANSMITTER INPUT CONNECTION 4-20 mA
("in" set to "420")
Installation note:
1.
The power supply voltage on the connector must be higher than the rated working voltage of the solenoid to be controlled.
2.
The IP rating depends on proper installation by the user. A round cable of 4 - 6 mm (0.15 - 0.25 in) diameter must be used.
3.
For „0 to 5 V DC" and for „0 to 10 V DC" command input drivers, it is recommended to use independent negative conductors for
power supply and analog output channel (PLC/PC) to maintain command signal accuracy due to voltage drop on long cables.
www.argo-hytos.com
Subject to change · EL6_9150_1en_02/2016
POWER SUPPLY
+9 / +36 V
1
0 V
2
REFERENCE SIGNAL
0 +10 V / 40-20 mA / 0+5 V
3
0 V SIGNAL
GND
Fuse
Power supply
9-36 V
Do not connect
Power supply
9-36 V
Power supply
9-36 V
Power supply
9-36 V
Do not connect
Power supply
9-36 V
Do not connect
PROPORTIONAL VALVE
GAIN 1
Command signal
REF
Command signal
REF
Command signal
Command signal
DITHER
Analog
output
0-10V
0 V
+5 V
Command signal
Analog
output
4-20 mA
From power supply
2 wire
transmitter
4-20 mA
Page 2