Argo-Hytos EL6 Manual de inicio rápido

Navegue en línea o descargue pdf Manual de inicio rápido para Unidad de control Argo-Hytos EL6. Argo-Hytos EL6 4 páginas. Digital control electronics unit

Imprimir página
Digital Control Electronics Unit - Plug-in Version
EL6
Functional Description
The control electronics is intended for the open-loop control of proportional valves with one solenoid. Its great advantage is its miniature design
in form of a socket for a standardized DIN connector base.
The unit supplies a variable current proportional to the reference signal, independently of temperature or load impedance variations.
To optimizie valve control and minimize valve hysterezis the unit contains a PWM stage to supply the solenoid.
The card's top surface contains two revolving selectors, a terminal block to connect supply and control wires, and a three-digit LED display.
The selector marked as "SELECT" is used to select the parameter to be adjusted. The second selector, marked as "ADJUST", is used to set the desired
value. In basic operational mode, the display shows an input/output parameter value; in adjustment mode, the selected parameter abbreviation
and the value being set up are indicated. The correct input signal type must be selected before operation.
Technical Data
Solenoid data
Operating voltage
Max. output current
Control signal type
Adjustable range of ramp functions
PWM / Dither frequency
Linearity
Operating ambient temperature
Recommended cross-section of lead-in wires
Enclosure type of the solenoid to EN 60529
Mass
Max. coil excitation current
of proportional directional valves
Attention: A cable with a circular cross-section and outside diameter of 4 to 6 mm should be used for the electronics supply,
only this way the declared degree of IP protection can be secured.
Page 1
Technical Features
› Digital electronics for open-loop control of a single proportional valve solenoid - plug-in version
› Independent adjustments (including ramp up and ramp down)
› Large, easy-to-use adjustments, readout on a 3-digit, 7-segment LED display
› Display of actual values direct adjustment (current & voltage)
› User selectable input type through menu setup (ex: 0 to 5V, 0 to 10 V, 4 to 20 mA)
› Wide range of supply voltage and ramp time (0 to 99.5 sec)
› Simple control with analog input, locally supplied reference voltage
› Energy efficient PWM circuit, no heat sink required
› Electronic limiting circuit/ short-circuit proof
› Reverse polarity, command input protection
› Load can be connected and disconnected live
› Mounting: DIN 43650-A/ISO 4400 solenoid terminal
V
A
s
Hz
%
°C (°F)
mm
2
kg (Ibs)
V
PRM2-04
PRM2-06
A
PRM6-10
9... 36 DC
0 - 5 [V], 0 - 10 [V], 4 - 20 [mA]
0.05... 99.5
40 - 450
-40... +75 (-40... +167)
0.5... +0.75
IP65
0.13 (0.29)
12
(Coil 16186100) ... 1.7
(Coil 16187500) ... 1.6
(Coil 16195800) ... 1.9
3
1
24
(Coil 16186200)... 0.8
(Coil 16186800)... 1.0
(Coil 16196200)... 1.1
www.argo-hytos.com
Subject to change · EL6_9150_1en_02/2016