ACU-RITE ENC 250 Manual de referencia - Página 9

Navegue en línea o descargue pdf Manual de referencia para Media Converter ACU-RITE ENC 250. ACU-RITE ENC 250 13 páginas. Linear encoder reading head
También para ACU-RITE ENC 250: Instrucciones de sustitución (2 páginas)

Imprimir página

ENC 250

™

MULTI-SECTION

Approximately [1/8"]

Insert straight pins here

to fasten ends of lip seals

If necessary pull the lip seal along at different points

along the inserted length. Insert the 4 straight pins from

the hardware kit into the ends of the lip seal grooves to

keep the lip seals from pulling away from the ends of the

scale case. Trim the lip seals ends with a pair of scissors

so that there is an overhang of approximately [1/8"] 3mm

at each end.

• Attach the right end cap with M3 x 12 CHM screws

provided in the hardware kit. Tighten these screws

securely to compress the end cap gasket.

Changing cable exit direction ...

Cover plate

T-10 Torx screw (2)

• Determine the cable exit direction before installing the

reading head.

• To change the cable exit direction; remove the cover plate

and rotate the cable 180°.

• The reading head is shipped attached to the installation

tool. Push the protruding roll pins of the reading head

installation tool assembly into the left end of the scale

case. Push on securely to close the gap between the scale

sections. The number indicators of the reading head

are always facing out.

3mm over hang

Straight pin

M3 x 12 CHMS

Plug

Armor cable hex crimp

Numbers on reading head

casting

• Support the reading head by hand, and remove the

alignment brackets by sliding them away from the reading

head and twisting them 45° to remove them from the

scale case. Gently pry them away from the reading head

with a small screw driver if needed.

• Slide the reading head onto the scale case to the center of

travel mark on the case.

• Reinstall the alignment brackets by inserting each at 45°

and twist to insert them into grooves on the bottom of

scale case. Slide brackets against the reading head until

they clip into place. Numbers and letters on reading head

casting and alignment brackets must correspond.

• Align the triangle on the reading head with the center-of-

travel mark previous placed on the scale.

• Return the axis back to its center of travel, and

lock in place.

Reading head

Acu-Rite Companies Inc.