Cisco Firepower 2110 Manual de software - Página 13

Navegue en línea o descargue pdf Manual de software para Hardware de red Cisco Firepower 2110. Cisco Firepower 2110 37 páginas. Rack-mount and ground the chassis
También para Cisco Firepower 2110: Manual (12 páginas), Manual de implantación (8 páginas), Primeros pasos (42 páginas)

Imprimir página

Cisco ASA and Firepower Threat Defense Reimage Guide

2015-09-24 19:46:28.400002 | 5760 | wtmp

([b] to go back or [s] to select a file to view, [Ctrl+C] to exit)

Type a sub-dir name to list its contents: s

Type the name of the file to view ([b] to go back, [Ctrl+C] to exit)

> install.log

Thu Sep 24 19:53:44 UTC 2015: Begin installation ...

Found hard drive(s): /dev/sda

Erasing files from flash ...

...

You can also view the upgrade.log, pyos.log, and commandd.log under /var/log/cisco with the same command

for boot CLI related issues.

Step 10

You can use either Firepower Device Manager or Firepower Management Center to manage your device. See

the Quick Start Guide for your model and your manager to continue setup:

http://www.cisco.com/go/ftd-asa-quick

Reimage from Firepower Threat Defense to ASA

To reimage the FTD to ASA software, you must access the ROMMON prompt. In ROMMON, you must

erase the disks, and then use TFTP on the Management interface to download the ASA image; only TFTP is

supported. After you reload the ASA, you can configure basic settings and then load the FirePOWER module

software.

Before you begin

• Ensure that you have a stable connection between the ASA and the TFTP server to avoid packet loss.

Procedure

Step 1

If you are managing the FTD from the Firepower Management Center, delete the device from the FMC.

Step 2

If you are managing the FTD using Firepower Device Manager, be sure to unregister the device from the

Smart Software Licensing server, either from the FDM or from the Smart Software Licensing server.

Step 3

Download the ASA image (see

the Management interface.

For the ASA 5506-X, 5508-X, 5516-X, ISA 3000: You must use the Management 1/1 port to download the

image. For the other models, you can use any interface.

Step 4

At the console port, reboot the Firepower Threat Defense device.

reboot

Enter yes to reboot.

Example:

> reboot

This command will reboot the system.

Please enter 'YES' or 'NO': yes

Download Software, on page

Continue?

Cisco ASA and Firepower Threat Defense Reimage Guide

Reimage from Firepower Threat Defense to ASA

2) to a TFTP server accessible by the FTD on