Cisco Firepower 4110 Manual - Página 12

Navegue en línea o descargue pdf Manual para Hardware de red Cisco Firepower 4110. Cisco Firepower 4110 42 páginas. Rack-mount and ground the chassis
También para Cisco Firepower 4110: Manual de mantenimiento y actualización (20 páginas), Manual (36 páginas), Manual (26 páginas), Manual (8 páginas), Primeros pasos (42 páginas)

Imprimir página

10-Gb Network Module

For More Information

10-Gb Network Module

The following figure shows the front panel of the 10-Gb network module (FPR4K-NM-8X10G). The

FPR4K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from

top to bottom, left to right.

Note

Overview

• See

10-Gb Network Module, on page 12

• See

40-Gb Network Module, on page 13

• See

100-Gb Network Module (Two Ports, Single Wide), on page 14

100-Gb network module.

• See

100-Gb Network Module (Four Ports, Single Wide), on page 15

100-Gb network module.

• See

Hardware Bypass Network Modules, on page 16

and the port configurations for the hardware bypass network modules.

• See

Install, Remove, and Replace the Network Module

network modules.

Make sure you have the correct firmware package and software version installed to support this network

module. For instructions on how to verify your firmware package version and to upgrade the firmware if

necessary, see the

Cisco Firepower 4100/9300 FXOS Firmware Upgrade

FXOS Compatibility

for the software compatibility matrix.

The FPR4K-NM-8X10G is NEBS-compliant.

You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be

populated at the same time, because of the port row spacing.

for a description of the 10-GB network module.

for a description of the 40-GB network module.

for a description of the two-port

for a description of the four-port

for the location and description of the LEDs,

for the procedure for removing and replacing

Guide. See

Overview

Cisco Firepower 4100/9300