Cisco Firepower 4150 Manual - Página 18
Navegue en línea o descargue pdf Manual para Hardware de red Cisco Firepower 4150. Cisco Firepower 4150 36 páginas. Rack-mount and ground the chassis
También para Cisco Firepower 4150: Manual de mantenimiento y actualización (20 páginas), Manual (26 páginas), Manual (8 páginas), Manual (42 páginas), Primeros pasos (42 páginas)
Imprimir página
Power Supply Modules
Insertion loss
Cable and operating
distance
Power Supply Modules
The Firepower 4100 supports two AC or DC power supply modules so that dual power supply redundancy
protection is available. Facing the back of the chassis, the power supply modules are numbered left to right,
for example, PSU1 and PSU2.
Note
Do not mix AC and DC power supply modules in one chassis.
Note
After removing power from the chassis either by moving the power switch to OFF or unplugging the power
cord, wait at least 10 seconds before turning power back ON.
Attention
Make sure that one power supply module is always active.
See
Remove and Replace the Power Supply Module
supply module.
AC Power Supply
The power supplies can supply up to 1100-W power across the input voltage range. The load is shared when
both power supply modules are plugged in and running at the same time. The power supply modules are
hot-swappable.
Table 7: AC Power Supply Module Hardware Specifications
Description
Input voltage
Overview
18
Normal
1.2 dB
Hardware bypass
1.5 dB
Core diameter (microns)
Modal bandwidth
(MHz/km)
G.652
Single mode
for the procedure for removing and replacing the power
Specification
100 to 240 V AC
Overview
1.6 dB
1.9 dB
Cable distance
Note
Half the
distance
specified by
the IEEE
standard.
5 km