Cisco Firepower 4150 Manual - Página 8
Navegue en línea o descargue pdf Manual para Hardware de red Cisco Firepower 4150. Cisco Firepower 4150 36 páginas. Rack-mount and ground the chassis
También para Cisco Firepower 4150: Manual de mantenimiento y actualización (20 páginas), Manual (26 páginas), Manual (8 páginas), Manual (42 páginas), Primeros pasos (42 páginas)
Rear Panel
5
7
Rear Panel
The following figure shows the rear panel of the Firepower 4100.
Figure 7: Firepower 4100 Rear Panel
1
3
5
7
9
The power switch is located to the left of power supply module 1 on the rear of the chassis. It is a toggle
switch that controls power to the system. If the power switch is in standby position, only the 3.3-V standby
power is enabled from the power supply module and the 12-V main power is OFF. When the switch is in the
ON position, the 12-V main power is turned on and the system boots.
You can shut down the chassis in one of two ways:
• Perform a graceful shutdown using the shutdown commands (see the
Overview
8
Active (ACT)
This LED is not supported; reserved for future
use.
Network activity
• Off—No connection or port is not in use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
Power on/off switch
Power supply module 2
Fan module 2
Fan module 4
Fan module 6
for the procedure). This may take several minutes to complete. Then toggle the power switch to the OFF
position. The power LED changes from solid green to off immediately.
6
Locator LED
• Off—Locate is off.
• Blue—Locate is on.
2
Power supply module 1
Fan module 1
4
6
Fan module 3
8
Fan module 5
10
Location for the two-post grounding lug
The two-post grounding lug is
Note
included in the accessory kit.
FXOS CLI Configuration Guide
Overview