Cisco GS7000 Manual de mantenimiento - Página 5

Navegue en línea o descargue pdf Manual de mantenimiento para Hardware de red Cisco GS7000. Cisco GS7000 15 páginas. Gainmaker node forward local injection module
También para Cisco GS7000: Manual de instrucciones de instalación (13 páginas), Solución de problemas (4 páginas), Manual de solución de problemas (12 páginas)

Maintenance

Removing and Replacing Modules

This procedure describes how to remove and replace the internal modules of the node. All field-replaceable

modules can be removed and replaced without removing power from the node.

Field-replaceable modules include:

• Forward optical receiver modules

• Reverse optical transmitter modules

• Status monitor/local control module

• Forward configuration module

• Reverse configuration module

• Equalizers

• Node signal directors

• Power supply modules

• RF amplifier assembly

• RPD Module

Caution

Removing power from the node will interrupt customer service. Removing any module, except for the status

monitor/local control module, will interrupt customer service unless that module has a redundant backup.

Follow this procedure to remove and replace an optical receiver, optical transmitter, optical amplifier, optical

switch, status monitor/local control module, or power supply module.

1. Open the housing. See

2. Carefully tag and remove any optical fibers from RPD, receiver or transmitter module.

Warning

Laser light hazard. Never look into the end of an optical fiber or connector. Failure to observe this warning

can result in eye damage or blindness.

3. Loosen the screws securing the module.

4. Lift the module straight up out of the housing to unplug it.

Opening and Closing the Housing, on page

Removing and Replacing Modules

Maintenance