Digitrax DZ126Z1 Manual - Página 2

Navegue en línea o descargue pdf Manual para Media Converter Digitrax DZ126Z1. Digitrax DZ126Z1 4 páginas. Fits azl z pa1 and others, z scale, mobile decoder, dcc board replacement, 2 fx3 functions

Imprimir página

Installation Information

For Most Z Scale layouts, Digitrax recommends using 8V DCC for operation, to

avoid heat damage to locomotive motors & shells. See the Digitrax Decoder Man-

ual for complete decoder test procedures, installation instructions, programming

and technical information. Digitrax manuals and instructions are updated peri-

odically. Please visit www.digitrax.com for the latest versions, technical updates

and additional locomotive-specific installation instructions.

Installation Instructions - AZL PA1 Locomotive

Remove the front coupler assembly then carefully remove the locomotive's

shell from the frame by holding the fuel tank and pulling the body shell up.

You can use toothpicks or similar to spread

the shell slightly. Note the orientation of

the shell to frame for reinstallation. Figure

1 shows the shell and light board removed

from the frame. The rear coupler is not

removed.

Carefully unscrew and save the 4 small

Phillips mounting screws holding the factory

light board.

Lift the light board gently to release it from

the motor wire loop contacts. Be careful not to distort these loops as you lift

the light board from the chassis.

Inspect the Motor wire loop contacts to make sure they are almost perpen-

dicular (85 – 90 degrees) to the frame top surface and are not damaged.

Carefully align these loops if necessary.

As shown in Figure 2 align the DZ126Z1

decoder with the small square black CPU

chip upwards and closest to the locomo-

tive front. Align each of the 2 motor wire

loop contacts with the holes in the two

gold contact pads in the middle of the

decoder. Gently press down so both of

these wire loops engage into their respec-

tive holes.

Align the PCB end mount holes with the

threaded mount holes on the frame castings. Place two screws at diagonal

corners and check the tolerances allow the PCB to be centered with the mo-

tor loops correctly engaged.

Place the final two corner screws, and tighten all 4 gently, to assure good

contact.

Place the chassis on a programming track and read the 2 digit address. If the

decoder address read fails, check you installation and motor contacts. Set

the address you wish to use.

Place the frame and decoder on some clean Z track and ensure the decoder

motion and LED lights work properly.

10. Replace the front coupler and locomotive shell.

Figure 1

Figure 2

— 2 —