argon audio FORTE MKII Inicio rápido - Página 2

Navegue en línea o descargue pdf Inicio rápido para Altavoces argon audio FORTE MKII. argon audio FORTE MKII 2 páginas.

Imprimir página

Quick start

Connect the speakers using the supplied speaker cable.

Connect the power cord into an electric outlet and into the back

of the left speaker (which has the amplifier). The LED light on

the loudspeaker will turn on.

To pair your Bluetooth device, turn on the speakers and press

"PAIRING" on your remote, until the LED starts blinking. Your

speakers are now in pairing mode. Activate Bluetooth on your

playback device and scan for devices. Your speaker will show

up as "Argon Audio FORTE MKII". Press "pair" and you are

connected. The LED light on the speaker will change to solid

blue. You're now ready to start listening to music!

Besides Bluetooth, your FORTE speakers have four more inputs:

HDMI ARC, OPT, AUX and Phono. FORTE will automatically switch

between the inputs, but you can also use the included remote

control to select your wished input.

When connecting a turntable to the Phono input on the FORTE

speaker, remember to also connect the ground wire from the

turntable to the metal GND screw (if applicable).

If you have an active subwoofer, connect it to the FORTE

speaker's SUB OUT using a subwoofer cable, and then connect

the cable to your subwoofer.

We recommend a running-in time of your FORTE speakers of

approximately 15-20 hours at normal listening level before you

decide on the final positioning of the speakers. During the

w w w . a r g o n a u d i o . c o m

FORTE MKII Quick start

running-in time the drive units will settle in and perform as

intended.

For optimal sound performance, the best listening position is at

ear level with the speakers placed not too far from a wall.

Basic operating

When the FORTE speakers receive input from any connected

source (except phono), they will automatically power on (if

powered off) and switch to the right input. This is called Auto

Power Up. Note: this will not happen if the speakers are already

powered on and playing from another source.

You can power the speakers off with Auto Power Up (APU)

disabled if needed: simply press and hold the power button on

remote control for 3 seconds when powering off. The speakers

will now power off with APU disabled.

The next time you turn on the speakers again, APU will be

enabled again.

You can always press the "PAIRING" button to reset all Bluetooth

connections when on the Bluetooth input.

To enable dimming of the LED on the front of the speaker,

power on the speaker and hold the mute button on the remote

for 5 seconds. The LED will now turn off after 5 seconds after

switching inputs. To disable LED dimming again, press and hold

mute for 5 seconds.