argon audio TT - 3 Manual - Página 4

Navegue en línea o descargue pdf Manual para Plato giratorio argon audio TT - 3. argon audio TT - 3 8 páginas.

7. 33/45 RPM Switch (33/off/45):

Select 33 or 45 rpm for playing a vinyl, switch to "OFF" to pause

the playing. Switch to 33 or 45 again, to continue the playing

from the pause point.

8. Signal Connectors

Plug in the RCA cable, and connect the cable to audio amplifier.

9. Ground Terminal

Connect a ground wire.

10. Power supply jack:

Plug-in DV12/0.5A switching adaptor for power supply.

Power Switch

11.

Turntable Platter and Belt Setup

1. Install the drive belt over the inner ring under the platter and

make sure it won't fall off during the

setup.

2. Place the platter through the turntable

spindle, then rotate the platter until you

see the drive motor pulley through the

window at the top left corner.

3. Carefully grab the drive belt and put it

around the slot of motor pulley.

4. Connect the power adapter to the turntable and power on the

turntable. Set the speed to either 33 or 45. If the platter does not

spin, try the steps listed above again.

5. Remember to place the rubber slip mat on the platter before

playing records.

T T - 3 M a n u a l