Digitrax DZ125IN Manual - Página 5

Navegue en línea o descargue pdf Manual para Juguete Digitrax DZ125IN. Digitrax DZ125IN 12 páginas. N scale mobile decoder 1 amp/1.25 amp peak 2 fx3 functions, 0.5 amp with 6 pin nem 651 type plug fit kato n-emd class 66 and others

Imprimir página

independently control each loco with a unique address. Digitrax decoders are

shipped with CV01 (AD2), the two digit address, set to 03. Following is a brief

description of how to change the decoder address with a Digitrax DT series

throttle. See your Starter Set Manual for complete programming instructions.

1 Place the loco on the programming track. Go into Program Mode on your

system. On DT400 press PROG. On DT300, DT100 & DT200 press

RUN/STOP & FN/F0.

2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT300 &

DT400). (Ad for DT100 & DT200, see your Starter Set manual for 4 digit

instructions).

3. Use your throttle to choose the address you want to set up for the decoder.

4. Complete address programming. On DT400 press ENTER. On DT300,

DT100 & DT200 press SEL.

Note: CV29 must also be programmed to enable 4 digit addressing, this is

done automatically by the DT300 & DT400 but not on earlier throttles.

4 4 5 5 0 0 C C e e m m e e t t e e r r y y S S t t r r e e e e t t

N N o o r r c c r r o o s s s s , , G G A A U U S S A A 3 3 0 0 0 0 7 7 1 1

w w w w w w . . d d i i g g i i t t r r a a x x . . c c o o m m

www.digitrax.com

7 7 7 7 0 0 - - 4 4 4 4 1 1 - - 7 7 9 9 9 9 2 2

T T

7 7 7 7 0 0 - - 4 4 4 4 1 1 - - 0 0 7 7 5 5 9 9

F F

s s a a l l e e s s @ @ d d i i g g i i t t r r a a x x . . c c o o m m

E E