argon audio tt-2 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Plato giratorio argon audio tt-2. argon audio tt-2 12 páginas.
También para argon audio tt-2: Manual del usuario (12 páginas), Manual del usuario (12 páginas)

Imprimir página

TT- 2

Connecting to a Computer

Connect the USB-output of the unit to a free USB-socket on your computer and turn it on/make sure it is powered on.

The "new hardware found assistant" will automatically detect the unit and announces it as a Microphone USB audio codec. There

is no need to install a driver manually.

After installation, one setting has to be done. For example - Windows 7® operating system:

Control Panel

Sound

Recording

Microphone USB Audio CODEC

Properties

Advanced: set to 2

channel, 16 bit, 48000 Hz (DVD Quality) Please note: Connection should be made to a USB-socket of your

computer directly. Connecting to USB-hubs or switches can cause problems.

Recording Programme

In case you do not have a recording programme installed on your computer, you may download one free from the

Internet. Recording programmes may be found by searching Google. In the menu of the recording programme,

source or input may have to be set to Microphone USB audio codec.

Please be aware that downloads from the Internet are made entirely at your own risk. Under no circumstances can

we carry responsibility or provide support for third-party software products sourced from the internet or for any

damage or problems arising from the use thereof. All downloads should be checked with an up-to-date anti-virus

programme. License fees may be applicable.

Mains power connection

The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to

ensure compliance with the mains rating in your house.

Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before connecting the power

supply to the mains.

Fitting the lid

Fit the lid carefully over the hinge fasteners and adjust the screws (14) until the lid stays open where you want it to without being

too stiff to open or close.

Switching on and off

Pressing the power switch (1) alternately starts or stops the motor.

w w w . a r g o n a u d i o . c o m