Cisco Performance Routing Engine 5 Manual de instalación del hardware - Página 17
Navegue en línea o descargue pdf Manual de instalación del hardware para Hardware de red Cisco Performance Routing Engine 5. Cisco Performance Routing Engine 5 35 páginas.
También para Cisco Performance Routing Engine 5: Manual de inicio rápido (2 páginas)
Imprimir página
Figure 11: Closing the Ejector Levers
Step 6
Using a Number 2 Phillips screwdriver, secure the PRE in the chassis by tightening the top and bottom captive screws.
Always tighten the captive screws on each newly-installed PRE to prevent accidental removal and provide
Caution
proper grounding for electromagnetic interference (EMI) shielding.
Step 7
When fully inserted, the PRE cycles through its power-on self-test. The FAIL LED comes on briefly (about 5 to 6 seconds)
and then goes off. If the FAIL LED remains on or is flashing, go to the
on page 26
section.
Step 8
Reconnect the cables.
For information about configuring the PRE, see the
Guide.
Troubleshooting the Cisco PRE5 Module Installation,
Cisco uBR10012 Universal Broadband Router Software Configuration
17