Cisco Performance Routing Engine 5 Manual de instalación del hardware - Página 20
Navegue en línea o descargue pdf Manual de instalación del hardware para Hardware de red Cisco Performance Routing Engine 5. Cisco Performance Routing Engine 5 35 páginas.
También para Cisco Performance Routing Engine 5: Manual de inicio rápido (2 páginas)
Imprimir página
• The PRE5 module must have the helper image (eboot) stored in the bootflash (bootflash0:), must have no configuration, and
must be set to boot into ROMMON mode. Individual PRE5 modules ship in this state.
• When upgrading from a PRE2 or a PRE4, copy your startup configuration and running configuration to the external USB disks
(disk1: or disk2:) of the PRE5 module.
Note
If you have redundant PREs installed in the Cisco uBR10012 chassis, and you intend to save the startup configuration, the
running configuration, and the new PRE5 image, be sure to save them to the external USB disks on both the primary and the
redundant PRE.
Saving the Startup and Running Configuration Information
When a PRE is removed from the chassis, any local configuration is lost. You must save your configuration information to the TFTP
server or the USB disks before removing the module.
Saving the Startup and Running Configuration Information to the TFTP Server
Procedure
Step 1
Connect to the primary PRE console from a terminal.
Step 2
Save the startup configuration and running configuration to the TFTP server or USB disks.
copy startup-config tftp://x.x.x.x/xxx.cfg
copy running-config tftp://x.x.x.x/xxx.cfg
copy startup-config disk1:xxx.cfg
copy running-config disk1:xxx.cfg
Upgrading the Primary PRE to a Cisco PRE5 Module
Procedure
Step 1
Connect a terminal to the primary PRE.
Step 2
If you have not already done so, save the startup configuration and running configuration to a location on a TFTP server.
For more information, see the
20.
When the PRE is removed from the chassis, any local configuration is lost. You must save your configuration
Caution
before removing the PRE.
Step 3
Power down the router. All traffic on the router is terminated.
Note
PREs can be hot-swapped. However, removing a PRE terminates all traffic, therefore we recommend that you
power down the router to ensure a successful installation.
20
Saving the Startup and Running Configuration Information to the TFTP Server, on page