Cisco PIX 501 Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Cisco PIX 501. Cisco PIX 501 21 páginas. Data sheet
También para Cisco PIX 501: Manual de inicio rápido (20 páginas), Ficha de datos (8 páginas), Manual de inicio rápido (20 páginas), Manual de inicio rápido (18 páginas)

Make sure the PC interface connected to the PIX 501 inside port, numbered 1 through 4, is set to

autonegotiate for best performance. If autonegotiate is not an option for the PC interface, set the speed

to either 10 or 100 Mbps half duplex. Setting the interface to full duplex causes a duplex mismatch that

significantly impacts the total throughput capabilities of the interface.

Follow these steps to power on the PIX Firewall:

Connect the power supply (341-0008-01) with the power cable (72-0259).

Step 1

Connect the small, round connector of the power supply cable to the power connector on the

Step 2

rear panel.

Connect the AC power connector of the power supply input cable to an electrical outlet.

Step 3

The PIX 501 does not have a power switch. Completing Step 3 powers on the device.

Note

Check the power LED, if it is solid green, then the device is powered on. For more

Step 4

information, refer to the "Check the LEDs" section on page 12.

P O W E R

C O N S O L

3 .3 V 4 .5

Cisco PIX 501

Power supply