Cisco PIX-515E Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Cisco PIX-515E. Cisco PIX-515E 42 páginas. Security appliance
También para Cisco PIX-515E: Manual de inicio rápido (42 páginas)

Imprimir página

Configuring the Security Appliance

This section describes the initial security appliance configuration. You can perform the setup steps

using either the browser-based Adaptive Security Device Manager (ASDM) or the command-line

interface (CLI).

To run the ASDM, you must have a DES license or a 3DES-AES license.

Note

About the Factory Default Configuration

Cisco security appliances are shipped with a factory-default configuration that enables quick startup.

This configuration meets the needs of most small and medium business networking environments. By

default, the security appliance is configured as follows:

• The inside interface is configured with a default DHCP address pool.

This configuration enables a client on the inside network to obtain a DHCP address from the

security appliance in order to connect to the appliance. Administrators can then configure and

manage the security appliance using ASDM.

• The outbound interface is configured to deny all inbound traffic through the outside interface.

This configuration protects your inside network from unsolicited traffic.

Based on your network security policy, you should also consider configuring the security appliance to

deny all ICMP traffic through the outside interface or any other interface that is necessary. You can

configure this access control policy using the icmp command. For more information about the icmp

command, refer to the Cisco Security Appliance Command Reference.