Epson 1250 - Perfection Photo Flatbed Scanner Manual básico - Página 41

Important Safety Instructions

Read all of these instructions and save them for later reference. Follow all warnings and instructions

marked on the scanner.

Place the scanner close enough to the computer for the interface cable to reach it easily.

Place the scanner and AC adapter near an electrical outlet where the power cord can be easily

unplugged.

Note for French-speaking users:

Installez le scanner et l'adapteur près d'une prise électrique permettant de débrancher facilement le

cordon d'alimentation.

Allow space behind the scanner for the cables, and space above the scanner so that you can raise

the document cover fully.

Keep the scanner and AC adapter away from high temperatures and humidity, and excessive dirt

or dust. Also avoid using or storing the scanner in places subject to rapid changes of temperature

and humidity.

Keep the scanner and AC adapter away from direct sunlight and strong light sources.

Unplug the scanner and AC adapter before cleaning. Clean with a damp cloth only. Do not use

liquid or aerosol cleaners.

Do not place the scanner or AC adapter on an unstable surface, near a radiator, or near a heat

source.

If you are not going to use the scanner, be sure to unplug the AC adapter from the electrical outlet.

Do not use the scanner or AC adapter near water, outdoors, or handle either device with wet

hands. Never insert or disconnect the power plug with wet hands.

Keep out of reach of children.

Use only the AC adapter that comes with your scanner. Using any other adapter could cause fire,

electrical shock, or injury.

The AC adapter is designed for use with the scanner with which it was included. Do not attempt

to use it with other electronic devices unless specified.

Use only the type of power source indicated on the AC adapter's label, and always supply power

directly from a standard domestic electrical outlet with the AC power cord that meets the relevant

local safety standards.

Power-supply cords should be protected from abrasion, cuts, crimping and kinking. Be sure to

place your cords to avoid any damage. Do not place objects on top of the power cord and the AC

adapter or allow the power cord to be stepped on or run over. You should take special care to try to

keep the power cord straight at the ends and the points where it enters and leaves the transformer.

Beware of electrical shock hazards.

Connect all equipment to properly grounded power outlets. Avoid using outlets on the same

circuit as photocopiers or air control systems that regularly switch on and off.

Important Safety Instructions