Cisco UCS B200 M3 Manual de instalación - Página 28

Navegue en línea o descargue pdf Manual de instalación para Hardware de red Cisco UCS B200 M3. Cisco UCS B200 M3 34 páginas. Blade server
También para Cisco UCS B200 M3: Nota de instalación y mantenimiento (36 páginas), Nota de instalación y mantenimiento (37 páginas), Manual (8 páginas), Manual de actualización (21 páginas), Nota de instalación y mantenimiento (28 páginas)

Installing a Modular LOM

The Cisco VIC 1240 is a specialized modular Lan on Motherboard (mLOM) adapter that provides dual 2 x 10 Gb of Ethernet/ or

Fiber Channel over Ethernet (FCoE) connectivity to each chassis. It plugs into the dedicated mLOM connector only. It is currently

the only card that can be plugged into the mLOM connector and it will provide connectivity through either a 2100 series or 2200

series IOM.

You must remove the adapter card to service the modular LOM.

Note

To install an mLOM on the blade server, follow these steps:

Procedure

Step 1

Position the mLOM's board connector above the motherboard connector and align the captive screw to the standoff post

on the motherboard.

Step 2

Firmly press the modular LOM's board connector into the motherboard connector.

Step 3

Tighten the captive screw.

To remove a modular LOM, reverse the above procedure. You might find it helpful when removing the connector

Tip

from the motherboard to gently rock the board along the length of the connector until it loosens.

Figure 22: Installing an mLOM