Cisco UCS B200 M3 Nota de instalación y mantenimiento - Página 29

Navegue en línea o descargue pdf Nota de instalación y mantenimiento para Hardware de red Cisco UCS B200 M3. Cisco UCS B200 M3 37 páginas. Blade server
También para Cisco UCS B200 M3: Manual de instalación (34 páginas), Nota de instalación y mantenimiento (36 páginas), Manual (8 páginas), Manual de actualización (21 páginas), Nota de instalación y mantenimiento (28 páginas)

Installing a mLOM Adapter

The Cisco VIC 1240 is a specialized modular Lan on Motherboard (mLOM) adapter that provides dual 2 x 10 Gb of Ethernet/ or

Fiber Channel over Ethernet (FCoE) connectivity to each chassis. It plugs into the dedicated mLOM connector only. It is currently

the only card that can be plugged into the mLOM connector and it will provide connectivity through either a 2100 series or 2200

series IOM.

You must remove the adapter card to service the mLOM.

Note

To install an mLOM on the blade server, follow these steps:

Procedure

Step 1

Position the mLOM's board connector above the motherboard connector and align the captive screw to the standoff post

on the motherboard.

Step 2

Firmly press the mLOM's board connector into the motherboard connector.

Step 3

Tighten the captive screw.

To remove an mLOM, reverse the above procedure. You might find it helpful when removing the connector from

Tip

the motherboard to gently rock the board along the length of the connector until it loosens.

Figure 21: Installing an mLOM