Epson 2400 - Perfection Photo - Dpi x Instrucciones de seguridad importantes

Notices

Important Safety Instructions

Read all of these instructions and save them for later reference. Follow all warnings and instructions

marked on the scanner.

Place the scanner close enough to the computer for the interface cable to reach it easily. Do not

place or store the scanner or the AC adapter outdoors, on an unstable surface, near excessive

dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature

or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity.

Do not use with wet hands.

Place the scanner near an electrical outlet where the power cord can be easily unplugged.

Note for French-speaking users:

Placez le scanner près d'une prise de courant où le cordon d'alimentation peut être débranché

facilement.

Allow space behind the scanner for the cables, and space above the scanner so that you can raise

the document cover fully.

Unplug the scanner and AC adapter before cleaning. Clean with a damp cloth only. Do not use

liquid or aerosol cleaners.

Keep out of reach of children.

Use only the type of power source indicated on the AC adapter's label, and always supply

power directly from a standard domestic electrical outlet with the AC power cord that meets

the relevant local safety standards.

Power-supply cords should be protected from abrasion, cuts, crimping and kinking. Be sure to

place your cords to avoid any damage. Do not place objects on top of the power cord or allow

the power cord to be stepped on or run over. Be particularly careful to keep all power-supply

cords straight at the ends and the points where they enter and leave the transformer.

Use only the AC adapter that came with your scanner. Using any other adapter could cause

fire, electrical shock, or injury.

The AC adapter is designed for use with the scanner with which it was included. Do not

attempt to use it with other electronic devices unless specified.

Connect all equipment to properly grounded power outlets. Avoid using outlets on the same

circuit as photocopiers or air control systems that regularly switch on and off.

Do not let the power cord become damaged or frayed.

If you use an extension cord with the scanner, make sure the total ampere rating of the devices

plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the

total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's

ampere rating. Do not place multiple loads on the electrical outlet.

Never disassemble, modify, or attempt to repair the AC adapter, scanner, film adapter, or

power cord.