Cisco Universal Broadband Router Cisco uBR10012 Manual - Página 15
Navegue en línea o descargue pdf Manual para Hardware de red Cisco Universal Broadband Router Cisco uBR10012. Cisco Universal Broadband Router Cisco uBR10012 28 páginas. Ac power entry module for the universal broadband router
También para Cisco Universal Broadband Router Cisco uBR10012: Manual de consulta rápida (38 páginas)
Imprimir página
Tip
If you want to replace both AC PEMs without shutting down the router, repeat this procedure for each
AC PEM, one at a time. Do not use this procedure if both AC PEMs have failed; instead, use the
procedure in the
Remove the front cover by lifting it up slightly and then pulling it toward you.
Step 1
Turn off the AC PEM you are replacing by pushing down the power switch to the standby position
Step 2
(Figure
Figure 5
AL AR MS
Caution
Do not power off both AC PEMs, or the system shuts down and all data traffic stops. Power off only the
AC PEM you are replacing.
Unplug the AC-input power cable from the power plug on the front panel of the AC PEM. For safety,
Step 3
also unplug the other end of the power cable from the AC-input power source.
For true redundant power protection, ensure that you are using a separate AC-input power source for
Tips
each AC PEM.
Use the screwdriver to loosen the captive screws on the AC PEM you are removing. Then pull the PEM
Step 4
from the chassis by using the handle on the faceplate
OL-24536-01
"Replacing Both AC PEMs" section on page
5).
Turning an AC PEM Off
AL AR MS
AC
SW ITC H
AC INP UT
200 -24 0V
13A 50/
60H z
AC INP UT
200 -24 0V
13A 50/
60H z
AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
AC
SW ITC H
A C IN P U
T
2 0 0 - 2 4 0
V
1 3 A 5 0 /6
0 H z
(Figure 6 on page
Removing and Replacing an AC PEM
19.
A C
S W IT C H
16). Set the AC PEM aside.
15