Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) Manual de instalación y configuración - Página 7
Navegue en línea o descargue pdf Manual de instalación y configuración para Hardware de red Cisco Versatile Interface Processor (VIP6-80) (VIP6-80). Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) 40 páginas. Versatile interface processor
Imprimir página
The VIP6-80 ROM monitor functions similarly to the boot loader image on the RSP, which runs a copy
of the Cisco IOS image. The boot loader image allows the router to access the Cisco IOS image when
powering up or initializing the system.
Port Adapter Slots
The VIP6-80 supports up to two single-width port adapters, or one dual-width port adapter.
shows a VIP6-80 with two single-width port adapter slots. A dual-width port adapter occupies both port
adapter slots (not shown).
To ensure proper airflow in the router and compliance with EMI prevention standards, a VIP6-80 with
one single-width port adapter must have a blank port adapter installed in the empty port adapter slot
location.
VIP6-80 does not support OIR of PAs. To install or replace port adapters, first remove the VIP6-80.
A VIP6-80 without at least one installed port adapter is not supported.
Note
The VIP6-80 does not support the PA-GE.
Table 4
The following table does not address which software release applies to the VIP6-80 port adapters. For
Note
more information, refer to the Software Advisor at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl.
Table 4
Port Adapters Supported by the VIP6-80
Product Number
Description
PA-A3-T3
ATM DS3 port adapter, enhanced
PA-A3-E3
ATM E3 port adapter, enhanced
PA-A3-8T1IMA
ATM inverse multiplexer over ATM port adapter
PA-A3-8E1IMA
ATM inverse multiplexer over ATM port adapter
PA-A3-OC3MM
ATM OC-3c/STM-1 multimode, enhanced
PA-A3-OC3SMI
ATM OC-3c/STM-1 single-mode intermediate reach (IR), enhanced
PA-A3-OC3SML
ATM OC-3c/STM-1 single-mode long reach (LR), enhanced
PA-A3-OC12-MM
ATM OC-12/STM-4 single-mode intermediate reach (IR); multimode
PA-A3-OC12-SMI
ATM OC-12/STM-4 single-mode intermediate reach (IR); multimode
PA-POS-OC3-MM
Single-wide OC-3c/STM-1
PA-POS-OC3-SMI
Single-wide OC-3c/STM-1
PA-POS-OC3-SML
Single-wide OC-3c/STM-1
PA-FE-TX
Fast Ethernet 100BaseTX
PA-FE-FX
Fast Ethernet 100BaseFX
PA-2FE-TX
Dual-Port Fast Ethernet 100BaseTX
OL-5078-01
identifies the port adapters supported by the VIP6-80 at the time of this writing.
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
Figure 1
Number of
Single or
Ports
Dual Width
1
Single
1
Single
8
Single
8
Single
1
Single
1
Single
1
Single
1
Dual
1
Dual
1
Single
1
Single
1
Single
1
Single
1
Single
2
Single
7