Cisco VIP4-50= Manual de instalación y configuración - Página 18
Navegue en línea o descargue pdf Manual de instalación y configuración para Hardware de red Cisco VIP4-50=. Cisco VIP4-50= 44 páginas. Fourth generation versatile interface processor
Imprimir página
VIP4 Installation Procedures
Figure 3
Failure to use the ejector levers and insert the interface processor properly can disrupt the order in which
Caution
the pins make contact with the card or interface processor. This may cause the system to interpret a board
failure.
Removing a VIP4
This section describes the procedure for removing a VIP4, an interface processor, or an
interface processor filler, and replacing it with a new VIP4. Please read the
Removal and Installation" section on page 15
To help prevent dust and contaminants from entering the chassis, do not leave the interface processor
Note
slot open. Either insert an interface processor filler in the empty slot, or proceed immediately to the
"Installing a VIP4" section on page
Caution
In Cisco 7507, Cisco 7507-MX, Cisco 7513, or Cisco 7513-MX routers with the high system availability
(HSA) or high availability (HA) feature enabled, online insertion and removal of any interface processor
in either CyBus might cause the standby RSP2 to reboot with a bus error or a processor memory parity
error. The active RSP recovers from this event and issues a "cBus Complex Restart" message. Systems
that are configured with an RSP4 or an RSP8 as the system standby are not affected and do not
experience this problem.
For more information on HSA or HA, refer to your RSP Installation and Configuration Guide.
Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide
18
Handling Interface Processors—Vertical Orientation Shown
19.
before proceeding with this procedure.
"Guidelines for VIP4
OL-3673-01