Cisco WS-C6509 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Hardware de red Cisco WS-C6509. Cisco WS-C6509 28 páginas. Catalyst 6500 series
También para Cisco WS-C6509: Manual de actualización (24 páginas), Ficha de datos (30 páginas)

Imprimir página

1. Catalyst 6509 Switch and Cisco 7606 and Cisco 7609 Routers

Position the rivet sleeve over one of the square cutouts on the opacity shield. Refer to

Step 10

rivet fastener placement. Press the rivet sleeve through the cutout, through the opacity shield material,

and through one of the chassis air vent perforations.

Note

Push the rivet pin through the rivet sleeve until you hear a click.

Step 11

Note

Repeat step 10 and step 11 for the remaining three snap rivet fasteners. Refer to

Step 12

fastener placement.

Due to decreased airflow when using the opacity shield, which is required for FIPS 140-2 validation,

Caution

short-term operation as specified by GR-63-CORE at 55º C is impacted. Short-term operation

requirements will only be met at 40º C. Without the opacity shield installed, the system will meet the

short-term operations requirements at 55º C.

We recommend that you replace the opacity shield every three months to prevent dust build-up and the

Caution

possibility of overheating the chassis. If the environment is especially dusty, inspect and replace the

opacity shield more often.

Note

If you need to remove the Catalyst 6509 chassis from the rack, you must first remove the opacity shield.

With the opacity shield installed, the chassis is too wide to slide out of the rack.

Catalyst 6509 Switch, Cisco 7606 Router, and Cisco 7609 Router with VPN Services Module Certification Note

OL-6334-01

You might need to try different cutouts to find the one cutout that aligns correctly with a chassis

air vent perforation.

If you do not hear a click, remove and inspect the snap rivet fastener. If the rivet sleeve appears

expanded or damaged, discard the snap rivet fastener and use a new one from the extras supplied

in the bag of fasteners.

Installing the Opacity Shield on the Catalyst 6509 Switch

Figure 5

for snap

for snap rivet