Cisco APIC L4 Manual de instalación y mantenimiento - Página 31

Navegue en línea o descargue pdf Manual de instalación y mantenimiento para Servidor Cisco APIC L4. Cisco APIC L4 46 páginas.

Installing the Server

• Remote setup—Use this procedure if you want to perform setup through your dedicated management

Note

This section contains the following topics:

Connecting to the Server Locally For Setup

This procedure requires the following equipment:

• VGA monitor

• USB keyboard

• Either the supported Cisco KVM cable (Cisco PID N20-BKVM); or a USB cable and VGA DB-15 cable

Step 1

Attach a power cord to each power supply in your server, and then attach each power cord to a grounded power outlet.

Wait for approximately two minutes to let the server boot to standby power during the first bootup. You can verify system

power status by looking at the system Power Status LED on the front panel. The system is in standby power mode when

the LED is amber.

Step 2

Connect a USB keyboard and VGA monitor to the server using one of the following methods:

• Connect an optional KVM cable (Cisco PID N20-BKVM) to the KVM connector on the front panel. Connect your

USB keyboard and VGA monitor to the KVM cable.

• Connect a USB keyboard and VGA monitor to the corresponding connectors on the rear panel.

Step 3

Open the Cisco IMC Configuration Utility:

a) Press and hold the front panel power button for four seconds to boot the server.

b) During bootup, press F8 when prompted to open the Cisco IMC Configuration Utility.

Note

The first time that you enter the Cisco IMC Configuration Utility, you are prompted to change the default

password. The default password is password. The Strong Password feature is enabled.

The following are the requirements for Strong Password:

• The password can have minimum 8 characters; maximum 14 characters.

• The password must not contain the user's name.

• The password must contain characters from three of the following four categories:

LAN.

To configure the system remotely, you must have a DHCP server on the

same network as the system. Your DHCP server must be preconfigured

with the range of MAC addresses for this server node. The MAC address

is printed on a label that is on the pull-out asset tag on the front panel. This

server node has a range of six MAC addresses assigned to the Cisco IMC.

The MAC address printed on the label is the beginning of the range of six

contiguous MAC addresses.

Connecting to the Server Locally For Setup

Cisco APIC M4/L4 Server Installation and Service Guide