Cisco Firepower 2130 Primeros pasos - Página 29

Navegue en línea o descargue pdf Primeros pasos para Servidor Cisco Firepower 2130. Cisco Firepower 2130 42 páginas. Rack-mount and ground the chassis
También para Cisco Firepower 2130: Manual (12 páginas), Manual de implantación (8 páginas), Instalación y mantenimiento (26 páginas)

Imprimir página

Getting Started

Configuration After Initial Setup

After you complete the setup wizard, the device configuration will include the following settings. The table

shows whether a particular setting is something you explicitly chose or whether it was defined for you based

on your other selections. Validate any "implied" configurations and edit them if they do not serve your needs.

Note

Setting

Password for admin user.

Management IP address.

Management gateway.

DNS servers for the

management interface.

Management hostname.

The Firepower 4100/9300 and ISA 3000 do not support the setup wizard. For the Firepower 4100/9300, all

initial configuration is set when you deploy the logical device from the chassis. For the ISA 3000, a special

default configuration is applied before shipping.

Configuration

Whatever you entered.

Obtained through DHCP.

FTDv: 192.168.45.45

Firepower 4100/9300: The management IP address you set when

you deployed the logical device.

The data interfaces on the device. Typically the outside interface

becomes the route to the Internet. The management gateway works

for from-the-device traffic only. If the device receives a default

gateway from the DHCP server, then that gateway is used.

Firepower 4100/9300: The gateway IP address you set when you

deployed the logical device.

ISA 3000: 192.168.45.1

FTDv: 192.168.45.1

The OpenDNS public DNS servers, IPv4: 208.67.220.220,

208.67.222.222; IPv6: 2620:119:35::35, or whatever you entered.

DNS servers obtained from DHCP are never used.

Firepower 4100/9300: The DNS servers you set when you

deployed the logical device.

firepower or whatever you entered.

Firepower 4100/9300: The hostname you set when you deployed

the logical device.

Configuration After Initial Setup

Explicit, implied, or default

configuration

Explicit.

Default.

Explicit.

Getting Started