Cisco Firepower Management Center 750 Manual de introducción - Página 12
Navegue en línea o descargue pdf Manual de introducción para Servidor Cisco Firepower Management Center 750. Cisco Firepower Management Center 750 42 páginas. Firepower management center
Imprimir página
(The FMC management interface is preconfigured with a default IPv4 address. However, you can reconfigure
the management interface with an IPv6 address as part of the setup process.)
2.
Using the supplied Ethernet cable, connect the network interface on the preconfigured computer directly to
the management interface on the appliance.
Confirm that the link LED is on for both the network interface on the local computer and the management
interface on the appliance.
3.
Use a web browser to navigate to the appliance's default IP address:
https:// 192.168.45.45
The login page appears.
4.
Log in using
admin
What to Do Next
Complete the setup process using the procedures in
Management Center Setup Using a Keyboard and Monitor (KVM)
You can connect a USB keyboard and VGA monitor to the appliance, which is useful for rack-mounted appliances
connected to a keyboard, video, and mouse (KVM) switch.
Before You Begin
Be sure you have, at minimum, the information needed to allow the appliance to communicate on your
management network:
—
An IPv4 or IPv6 management IP address
—
A netmask or prefix length
—
A default gateway
Procedure
1.
Using the supplied Ethernet cable, connect the management interface on the back of the appliance to a
protected management network.
2.
Connect the monitor to the VGA port and the keyboard to one of the USB ports.
3.
Access the Linux shell on the FMC using using
that the password is case-sensitive.) Use the steps appropriate to your Firepower version; see
CLI or the Linux Shell on the FMC, page
4.
Run the following script:
sudo /usr/local/sf/bin/configure-network
The following prompt (appended with the current value) appears:
Management IP address?
5.
Enter the IP address you want to assign to the management interface or press Enter to accept the current
value. For example:
10.2.2.20
The following prompt (appended with the current value) appears:
Management netmask?
6.
Enter the netmask for the interface's IP address or press Enter to accept the current value. For example:
Cisco Firepower Management Center Getting Started Guide
as the username and
Admin123
3.
Installation and Initial Setup for Versions 5.4 - 6.4.x
as the password.
Initial Setup Page: Management Centers, page
as the username and
admin
as the password. (Note
Admin123
Accessing the
13.
12