Cisco Firepower Management Center 750 Manual de introducción - Página 27
Navegue en línea o descargue pdf Manual de introducción para Servidor Cisco Firepower Management Center 750. Cisco Firepower Management Center 750 42 páginas. Firepower management center
Imprimir página
The red LILO menu appears offering two options: to restore the current version of the system, or to perform
a system restore (System_Restore). Use the arrow keys to select System_Restore and press Enter.
The
: prompt appears after the following choices:
boot
0. Load with standard console
1. Load with serial console
Type
and press Enter.
0
—
For a serial connection:
The LILO boot prompt appears. For example:
LILO 24.2 boot:
6.4.0
boot:
Type
System_Restore
The
: prompt appears after the following choices:
boot
0. Load with standard console
1. Load with serial console
Type
and press Enter.
1
5.
Press Enter to confirm the copyright notice.
6.
Unless this is the first time you have restored the appliance to this major version, the utility automatically loads
the last restore configuration you used. To continue, confirm the settings in a series of pages until the "Cisco
Firepower Appliance <Version> Configuration Menu" appears.
What to Do Next
Continue with
Starting the Restore Utility Using Lights-Out Management
If you need to restore an appliance to factory defaults and do not have physical access to the appliance, you can
use LOM to perform the restore process. Note that you can use Lights-Out Management on the default (
management interface only.
Caution:
When restoring FMC models 750, 1500, or 3500 to factory settings using LOM, if you do not have
physical access to the appliance and you delete the license and network settings, you will be unable to
access the FMC after the restore.
Caution:
When restoring FMC models 2000 or 4000 to Version 6.3+ using LOM, if you do not have physical
access to the appliance and you delete the license and network settings, you will be unable to access the
FMC after the restore.
Note:
Before you can restore an appliance using LOM, you must enable the feature; see
Management, page
To start the restore utility using Lights-Out Management:
1.
Access the Linux shell using the
Accessing the CLI or the Linux Shell on the FMC, page
2.
At your computer's command prompt, enter the IPMI command to start the SOL session:
For IPMItool, type:
Cisco Firepower Management Center Getting Started Guide
System_Restore
and press Enter.
Using the Interactive Menu to Restore an Appliance, page
36.
admin
Restoring a Firepower Management Center to Factory Defaults
account. Use the steps appropriate to your Firepower version; see
3.
28.
Setting Up Lights-Out
)
eth0
27