Cisco ONS 15454 SDH E1-75 Manual - Página 21

Navegue en línea o descargue pdf Manual para Servidor Cisco ONS 15454 SDH E1-75. Cisco ONS 15454 SDH E1-75 40 páginas. Impedance conversion panel
También para Cisco ONS 15454 SDH E1-75: Manual de consulta rápida (16 páginas), Manual de referencia (22 páginas), Instalación de (13 páginas)

Imprimir página

Chapter 11 Circuits and Tunnels

Several rules apply to secondary sources and destinations:

•

For bidirectional circuits, CTC creates an SNCP connection at the source node that allows traffic to be

selected from one of the two sources on the ONS 15454 SDH network. If you check the Fully Path

Protected option during circuit creation, traffic is protected within the ONS 15454 SDH network. At the

destination, another SNCP connection is created to bridge traffic from the ONS 15454 SDH network to

the two destinations. A similar but opposite path exists for the reverse traffic flowing from the

destinations to the sources. For unidirectional circuits, an SNCP drop-and-continue connection is created

at the source node.

Note

Automatic routing and its associated subfields are not available if both the Automatic Circuit Routing

NE default and the Network Circuit Automatic Routing Overridable NE default are set to FALSE. For a

full description of these defaults see

11.14 Manual Circuit Routing

Routing circuits manually allows you to:

•

CTC imposes the following rules on manual routes:

•

78-18119-01

CTC does not allow a secondary destination for unidirectional circuits, because you can always

specify additional destinations after you create the circuit.

Primary and secondary sources should be on the same node.

Primary and secondary destinations should be on the same node.

DRI and open-ended SNCP nodes allow primary and secondary sources and destinations on

Note

different nodes.

Secondary sources and destinations are permitted only for regular high-order or low-order

connections (not for low-order tunnels and multicard EtherSwitch circuits).

For point-to-point (straight) Ethernet circuits, only VC endpoints can be specified as multiple

sources or drops.

Choose a specific path, not necessarily the shortest path.

Choose a specific VC4/VC3/TUG3/TUG2/VC12/VC11 on each link along the route.

Create a shared packet ring for multicard EtherSwitch circuits.

Choose a protected path for multicard EtherSwitch circuits, allowing virtual SNCP segments.

All circuits, except multicard EtherSwitch circuits in a shared packet ring, should have links with a

direction that flows from source to destination. This is true for multicard EtherSwitch circuits that

are not in a shared packet ring.

If you enabled Fully Path Protected, choose a diverse protect (alternate) path for every unprotected

segment

(Figure

11-7).

Appendix C, "Network Element Defaults."

Cisco ONS 15454 SDH Reference Manual, R8.5

11.14 Manual Circuit Routing

11-21