Cisco Secure Network Server 3600 Series Manual de instalación del hardware - Página 29

Navegue en línea o descargue pdf Manual de instalación del hardware para Servidor Cisco Secure Network Server 3600 Series. Cisco Secure Network Server 3600 Series 38 páginas. Appliance

Imprimir página

1. Cisco Sns 3600 Series Appliance Hardware Specifications

Installing the Appliance

Step 2

Choose one of the following options for NIC redundancy:

• None—The Ethernet ports operate independently and do not fail over if there is a problem. This setting can be

used only with the Dedicated NIC mode.

• Active-standby—If an active Ethernet port fails, traffic fails over to a standby port. Shared LOM and Cisco Card

modes can use Active-standby or Active-active settings.

• Active-active (default)—All Ethernet ports are used simultaneously. You must use only this NIC redundancy

setting if you have selected the Shared LOM EXT mode. Shared LOM and Cisco Card modes can use Active-standby

or Active-active settings.

Step 3

Choose whether to enable DHCP for dynamic network settings, or to enter static network settings.

Before you enable DHCP, you must preconfigure your DHCP server with the range of MAC addresses for

Note

this server. The MAC address is printed on a label on the rear of the server. This server has a range of six

MAC addresses assigned to Cisco IMC. The MAC address printed on the label is the beginning of the range

of six contiguous MAC addresses.

The Static IPv4 and IPv6 Settings include the following:

• Cisco IMC IP address—For IPv6, valid values are 1 - 127.

• Gateway—For IPv6, if you do not know the gateway, you can set it as none by entering :: (two colons).

• Preferred DNS Server Address—For IPv6, you can set this as none by entering :: (two colons).

Step 4

(Optional) Configure VLAN settings.

Step 5

(Optional) Set a hostname for the server.

Step 6

(Optional) Enable dynamic DNS and set a dynamic DNS (DDNS) domain.

Step 7

(Optional) If you check the Factory Default check box, the server reverts to the factory defaults.

Step 8

(Optional) Set a default user password.

The factory default username for the server is admin. The default password is password.

Note

Step 9

(Optional) Enable auto-negotiation of port settings or set the port speed and duplex mode manually.

Auto-negotiation is applicable only when you use the Dedicated NIC mode. Auto-negotiation sets the port

Note

speed and duplex mode automatically based on the switch port to which the server is connected. If you disable

auto-negotiation, you must set the port speed and duplex mode manually.

Step 10

(Optional) Reset port profiles and the port name.

Step 11

Press F5 to refresh the settings that you made. You might have to wait about 45 seconds until the new settings appear

and the message, "Network settings configured" is displayed before you reboot the server in the next step.

Step 12

Press F10 to save your settings and reboot the server.

If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed during bootup.

Note

Setting Up the System With the Cisco IMC Configuration Utility

Cisco Secure Network Server 3600 Series Appliance Hardware Installation Guide